ToolSphere
All perfboard layouts

Voltage Divider Perfboard Layout

Two resistors in series between an input voltage and ground, with the point between them taken off as a lower output. This board uses two 10 kΩ resistors, so the output is half the input.

Voltage divider perfboard layoutR1 10kR2 10k
Open this layout in the simulator Connection check: no shorts, 3 named nets

Red wires carry power, white is ground, yellow and blue are signals. Every hole is an isolated pad; connections are the wires shown. In the simulator you can move parts, add your own and re-run the check.

Parts list

As an Amazon Associate, ToolSphere earns from qualifying purchases.

How it works

The output is a fixed fraction of the input:

VOUT = VIN × R2 ÷ (R1 + R2) = VIN × 10k ÷ 20k = VIN ÷ 2

To read a battery of up to 12 V with a 5 V microcontroller input, use R1 = 15 kΩ and R2 = 10 kΩ: 12 × 10 ÷ 25 = 4.8 V at full charge.

A divider is a signal circuit, not a power supply. Whatever you connect to VOUT is in parallel with R2 and pulls the voltage down; an ADC input (very high impedance) is fine, a motor or LED is not. Use a regulator such as the 7805 for power.

Building it, step by step

  1. Run VIN along the top row and GND along the bottom row.
  2. Fit R1 from the VIN rail down, then R2 below it to the GND rail.
  3. Join R1's lower leg to R2's upper leg; that junction is VOUT.
  4. Take a wire from the junction across to where VOUT is needed (an ADC pin or a header).
  5. Measure VOUT with no load connected: it should be half of VIN.

Tools for this build

Frequently asked questions

How do I calculate a voltage divider?

VOUT = VIN × R2 ÷ (R1 + R2), where R2 is the resistor to ground. The voltage divider calculator also suggests standard resistor pairs for a target ratio.

Why does my divider output drop when I connect something?

The load sits in parallel with R2, lowering the effective resistance. Keep the load at least ten times R2, or buffer the output with an op-amp.

Can I power a circuit from a voltage divider?

No. It wastes current and the output sags under load. Use a voltage regulator such as a 7805 or a buck converter.