ToolSphere
All perfboard layouts

Two-Transistor LED Flasher Perfboard Layout

A discrete astable that alternates two LEDs without a microcontroller. The two transistor stages switch each other through cross-coupled capacitors.

Two-transistor LED flasher perfboard layoutJ1 5VQ1 2N3904Q2 2N3904R1 1kR2 1kR3 47kR4 47kD1 LEDD2 LEDC1 10uC2 10uC3 100n
Open this layout in the simulator Connection check: no shorts, 8 named nets

Red wires carry power, white is ground, yellow and blue are signals. Every hole is an isolated pad; connections are the wires shown. In the simulator you can move parts, add your own and re-run the check.

Parts list

As an Amazon Associate, ToolSphere earns from qualifying purchases.

How it works

Each collector pulls its LED low through a 1 kΩ series resistor. Using 5 V supply, an assumed 2 V red LED drop and 0.2 V saturated collector drop, the resistor library gives 2.8 mA per conducting LED: (5 − 2 − 0.2) / 1000. This is an estimate, not a measurement of the actual LED or transistor.

The 47 kΩ base resistors and 10 µF coupling capacitors set the rough switching time. The scratch calculation gives ln(2) × 47000 × 10 µF = 0.326 s per half-cycle, approximately 1.53 Hz for a complete alternating cycle. LED loading, transistor thresholds and capacitor tolerance change the real timing; this is a first-order RC estimate, not a simulated waveform.

C1 goes from Q1's collector to Q2's base, while C2 goes from Q2's collector to Q1's base. The capacitor positive ends face the collectors. A small imbalance starts the alternating action. The onsemi 2N3904 documentation identifies the emitter/base/collector pinout; verify the actual manufacturer's package before soldering.

Use this particular example at the stated 5 V supply. Raising the supply can increase the reverse base-emitter stress created by the coupling capacitors; this drawing is not a general higher-voltage flasher design. C3 bypasses the supply.

Use isolated-pad perfboard with insulated underside jumpers. The labelled top-row junctions join only their named nets; crossing diagonal wires are not solder joints. There are no stripboard track cuts in this layout.

Building it, step by step

  1. Fit both 2N3904 transistors with emitter, base and collector matching the footprint labels; do not assume every TO-92 transistor shares this order.
  2. Connect emitters to GND. Run each 1 kΩ resistor from +5V to its LED anode and each LED cathode to its transistor collector.
  3. Fit each 47 kΩ resistor from +5V to a base.
  4. Cross-couple the collectors to opposite bases through the 10 µF capacitors, positive ends toward collectors. Fit the 100 nF supply bypass.
  5. Check the unpowered board for supply shorts and accidental same-side capacitor connections, then apply the stated supply and observe alternation.

Tools for this build

Frequently asked questions

Why must the capacitors cross to the opposite base?

That coupling makes a collector transition switch the opposite stage. Connecting both capacitors to their own stage is a different circuit and does not implement this astable.

Can I make the LEDs blink more slowly?

Increasing the timing resistance or capacitance increases the approximate RC interval. Check transistor drive, capacitor polarity and actual behavior after changing values; the simple timing estimate omits device thresholds and LED loading.

Why do both LEDs stay on?

Check the transistor pin order, collector-to-opposite-base capacitor connections and for solder bridges. The connection checker verifies named wiring, not transistor health or capacitor leakage.

Are track cuts needed?

No: this layout uses isolated-pad perfboard. Do not transfer it unchanged to continuous copper stripboard.