ToolSphere
All perfboard layouts

Stripboard LED Layout With Track Cuts

The same LED and resistor as the perfboard version, on stripboard: long copper strips already join each row, so most wiring is done for you, but you must cut a strip wherever a connection has to stop.

Stripboard LED (cuts) stripboard layoutR1 330RLED
Open this layout in the simulator Connection check: no shorts, 2 named nets, 2 track cuts

Red wires carry power, white is ground, yellow and blue are signals. Copper strips run left to right; ⊘ marks a track cut. In the simulator you can move parts, add your own and re-run the check.

Parts list

As an Amazon Associate, ToolSphere earns from qualifying purchases.

How it works

Here the resistor and LED lie along one strip. Without cuts, the strip would join both legs of each part and short it out: the resistor would do nothing and the LED would never light.

A track cut between each part's legs splits the strip into sections, so current has to flow through the parts in turn: +5V → resistor → LED → GND. Cuts are made with a spot-face cutter or a 3–4 mm drill bit turned by hand until the copper ring around the hole is gone.

Laying parts across strips instead needs fewer cuts; laying them along strips, as here, is compact but every part needs a cut under it.

Building it, step by step

  1. Plan which strip carries which net before soldering anything.
  2. Make the two track cuts first, between the legs of the resistor and of the LED.
  3. Fit the resistor and LED along the strip, anode towards the resistor.
  4. Add the wire from +5V to the resistor's strip section and from the LED's section to GND.
  5. Check each cut with a multimeter: no continuity across it.

Tools for this build

Frequently asked questions

What is a track cut on stripboard?

A break in a copper strip, made by drilling away the copper around one hole, so the two sides of the strip are no longer connected.

How do I cut tracks on Veroboard?

Use a spot-face cutter or a 3–4 mm drill bit twisted by hand in the hole until the copper ring is gone. Check with a multimeter that the strip no longer conducts across the cut.

Stripboard or perfboard?

Stripboard needs fewer wires for circuits built around a chip; perfboard is more flexible for dense or irregular layouts. The simulator does both.