ToolSphere
All perfboard layouts

RC Low-Pass Filter Perfboard Layout

One resistor in series and one capacitor to ground make a low-pass filter: slow signals pass, fast ones are shunted to ground. This board uses 1.6 kΩ and 100 nF for a cutoff near 1 kHz, with input and output headers.

RC low-pass filter perfboard layoutJ1 INR1 1k6C1 100nJ2 OUT
Open this layout in the simulator Connection check: no shorts, 3 named nets

Red wires carry power, white is ground, yellow and blue are signals. Every hole is an isolated pad; connections are the wires shown. In the simulator you can move parts, add your own and re-run the check.

Parts list

As an Amazon Associate, ToolSphere earns from qualifying purchases.

How it works

fc = 1 ÷ (2π × R × C) = 1 ÷ (2π × 1600 Ω × 100 nF) ≈ 995 Hz

At 995 Hz the output is 3 dB down (about 71% of the input amplitude). Above that it falls 20 dB per decade: a 10 kHz signal comes out at about a tenth of its input.

Typical uses: smoothing a PWM output into a steady voltage, removing high-frequency noise before an ADC, or taming a noisy sensor line. For PWM smoothing, pick fc well below the PWM frequency (an Arduino's default PWM on most pins is about 490 Hz, so use a much lower cutoff, for example 10 kΩ and 10 µF for 1.6 Hz).

Whatever reads the output should have an input resistance at least ten times R, or it shifts the cutoff.

Building it, step by step

  1. Run GND along the bottom row.
  2. Fit the input header (IN, GND) on the left and the output header on the right.
  3. Fit R1 in series from IN to the output node.
  4. Fit C1 from the output node to GND.
  5. Check with a signal generator or a PWM pin and an oscilloscope: the output should be smoother than the input.

Tools for this build

Frequently asked questions

How do I calculate an RC filter cutoff?

fc = 1 ÷ (2π × R × C). With 1.6 kΩ and 100 nF that is about 995 Hz. The RC filter calculator works it out for any pair.

How is a high-pass filter different?

Swap the parts: capacitor in series, resistor to ground. The cutoff formula is the same, but it passes frequencies above fc instead of below.

Can an RC filter turn PWM into an analog voltage?

Yes, roughly: choose fc far below the PWM frequency. The output will still have some ripple; a second RC stage or an op-amp filter reduces it.