Robotics Lab
For robotics coursework and builds: describe the arm, size the motors that move it, tune the control loop, and pick a battery that lasts. Every formula is worked through on the page.
1. Describe the arm
Write the arm as a DH table and get every link transform and the end-effector pose, then solve the planar arm forwards and backwards.
2. Size the motors
Work out the holding torque each joint needs, the drive torque and speed for a wheeled robot, and stepper speed, steps per mm and torque units for printers and CNC.
Robotic Arm Joint Torque Calculator
Estimate static holding torque for a horizontal two-link arm
Robot Drive Speed & Torque Calculator
Estimate wheel speed and drive torque for a wheeled robot
Stepper Motor Speed & Step Calculator
Convert step rate to RPM and work out steps per millimetre
Motor KV to RPM Calculator
Estimate brushless motor RPM from KV and battery cells
3. Control
Get starting PID gains from a step test or the ultimate-gain method, see the closed-loop response, and convert sensor orientation between quaternions and Euler angles.
4. Power
Choose a LiPo by cell count, capacity and C rating, estimate run time, and for drones balance motor thrust against weight and flight time.
LiPo Battery Charge Rate Calculator
Work out LiPo currents, pack voltages and estimated charge time
Battery Run Time Calculator
Estimate battery run time from capacity and current draw
Propeller Thrust Calculator
Estimate static propeller thrust from shaft power and diameter
Drone Flight Time Calculator
Estimate hover time from battery capacity and current or weight
Other labs
Frequently asked questions
Do the kinematics tools use standard or modified DH?
The DH calculator supports both, with presets for common arms such as the PUMA 560 and UR5. The forward kinematics tool solves a two-link planar arm, the inverse kinematics tool a two-link arm or a three-link arm with a set tool angle, and both draw it.
Can I use these for an FRC or university robotics project?
Yes. The PID helper, motor and battery tools are aimed at exactly that, and each page shows the formula and a worked example so you can check the numbers in your report.