Electronics Lab
Everything here runs in your browser with nothing to install. The tools are ordered the way a project usually goes: work out the values, pick the parts, then plan the board and wire it up.
1. Work out the values
Start with the circuit on paper: currents, voltages, and the resistances that set them. Combine resistors into the value you need, and check how much power each part dissipates before choosing its rating.
Ohm's Law Calculator
Find voltage, current, resistance or power from known values
Series/Parallel Equivalence Calculator
Combine resistors, capacitors or inductors in series or parallel
Voltage Divider Calculator
Find the output voltage between two resistors
LED Resistor Calculator
Choose a series resistor and power rating for your LEDs
2. Choose and read the parts
Decode resistor bands and capacitor codes, size the timing parts for a 555, and pull the key limits out of a datasheet before you order.
Resistor Color Code Decoder
Pick resistor band colors to read resistance and tolerance
Capacitor Code Decoder
Read capacitance and tolerance from printed capacitor codes
555 Timer Calculator
Work out 555 oscillator timing or a one-shot pulse width
AI Datasheet Analyzer
Search a datasheet PDF or ask questions with page references
3. Filters and signals
For anything that handles signals rather than steady currents: cut-off frequencies, resonance, and how gain falls with frequency.
RC Filter Cutoff Frequency Calculator
Find an RC filter's cutoff frequency from resistance and capacitance
LC Resonant Frequency Calculator
Find resonant frequency from inductance and capacitance
Bode Plot Generator
Plot gain and phase from a transfer function
Decibel (dB) Converter
Convert power and voltage ratios to decibels and back
4. Plan the board
Lay the circuit out on a perfboard or stripboard grid before you solder, size the copper for the current if you are making a PCB, and choose wire that will not run hot.
PerfBoard & Stripboard Simulator
Plan perfboard or stripboard layouts and check connections
PCB Trace Width Calculator
Estimate PCB trace width, current capacity and voltage drop
AWG Wire Gauge Calculator
Look up wire diameter, area and copper resistance by AWG
Thermal Resistance Calculator
Estimate junction temperature from power and thermal resistance
5. Connect a microcontroller
Plan which Arduino pins go where (PWM, analogue, I²C, interrupts) so the wiring and the code agree from the start.
Other labs
Frequently asked questions
Are these electronics tools free?
Yes. There is no sign-up and no paid tier, and the calculations run in your browser, so your designs are not uploaded anywhere.
Can the perfboard simulator check that my circuit works?
It checks connectivity: which holes, wires and parts are joined, and whether every net you meant to connect actually is. It does not simulate voltages and currents; use the calculators above for those.
Which tool should I start with for an LED project?
The LED resistor calculator for the resistor value and its power, then the perfboard simulator to lay out the board. If you are driving the LEDs from an Arduino, plan the pins in the Arduino pin planner.